Table of Contents
Advertisement
44
Position the FootRest on the bike and loosely thread the two
8 mm bolts through the front mounting plate and into the
threads on the frame. You may need an extra hand to help
hold up the UtilityRack while you thread in these bolts. The
bottom portion of the rear clamp should fall underneath
the UtilityRack.
46
Go back to the front bolts on the mounting plate. Tighten
these using a 5 mm Allen wrench.
45
Attach the top portion of the rear clamp over the bottom
rail of the UtilityRack. Loosely thread two 4 mm bolts with
washers into the top of the clamp. Do not tighten the bolts
completely at this time.
47
Use a 4 mm Allen wrench to evenly tighten the bolts on the
rear clamp until the FootRests are securely attached to
the frame.
13
Advertisement
Table of Contents
