Panasonic NAVI smart Quick Reference page 42

3.
Confirm that the QR code is displayed in the marking image editor.
4.
Depending on your code data, specify any of the
following parameters:
• Standard: If the code data contains Simplified
Chinese characters, select "GB/T 18284". If you
select "ISO/IEC 18004", you can set Japanese
characters.
• Mode (QR): Select the mode depending on
the character type. If "Auto" is set, the mode is
selected automatically depending on the code
data.
5.
Depending on your desired code specification,
specify any of the following parameters:
• Model: In most cases, "Model2" is used.
• Error correction level
• Version: The allowed number of input characters
depends on the selected version. If "Auto" is set,
the version is selected automatically depending
on the code data.
• Number of quiet modules: If "Auto" is selected,
the quiet zone width is set according to the code's
requirements for the minimum width.
6.
Specify the module size to enter the value of the following parameters:
• Module height [mm]
• Module width [mm]
In this example, 0.5mm is set for the both values.
The entire width and height of the code, including the quiet zone are displayed in "Total width [mm]" and "Total height
[mm]".
• For details of the QR code settings, refer to the "Laser Marker NAVI smart Operation Manual".
42
4
5
4
5
6
ME-NAVIS2-QR-1