Accessory Installation - Uplift Desk C-Frame Manual

Now is a good time to install any accessories such as a Wire Management Tray, CPU Holder, Keyboard Tray, or
other items that attach to the underside of your desktop. This section will cover accessories that are included with
your desk frame. For other accessories, refer to the instructions that were provided with those products.
Cable Mounts (H9)
Use the included Cable Mounts (H9) to organize
your wires and keep them tidy and out of the way.
The Cable Mounts can help prevent cables from
snagging on stationary objects while the desk is
moving. The Cable Mounts consist of an adhesive-
backed plastic anchor and a reusable hook and
loop strip.
The adhesive backing on the anchor is very strong.
Please carefully decide locations before adhering
them to your desktop or desk frame. You can also
use the hook and loop strips without the plastic
anchor in places where it can be slid underneath
frame parts. You might want to save some of the
Cable Mounts for cable management of personal
devices after completing the desk assembly.
Anchor Plates (P11)
Various UPLIFT Desk accessories were designed
to attach to the patented mounting points located
along the sides of the Crossbar Ends on UPLIFT
V2 and V2-Commercial desk frames. Some of
these accessories require the use of the Anchor
Plates (P11) included with the desk frame. Refer to
the instructions provided with each accessory for
specific mounting instructions.
If the Anchor Plates are required, attach them using
two of the M8x10 Machine Screws (H7) per Anchor
Plate and tighten the screws using the 5mm Allen
Wrench (H8) and Allen Wrench Handle (H15).

Accessory Installation

P12
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
Wire Management Tray (P12)
Most UPLIFT desktops include two pre-drilled holes
about 12" apart located near the back of the desktop.
If your desktop includes grommets, these holes will
be located between them. These holes are meant for
attaching the included Wire Management Tray (P12).
If you choose to place the tray in a different location,
make a pencil mark at each mounting hole location and
drill pilot holes. Attach the tray to your desktop using
two #10x5/8" Wood Screws (H14).
P11
H7
13