Uplift Desk CHR454 Instructions

Package Contents:

UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
Part 1 Part 2
Seat Neck

Step 1

The Cylinder (part 3) comes with a plastic cap which protects the gas-release
button during shipment. Remove this plastic cap from the end of the Cylinder,
and dispose of it.

Step 2

Place the larger end of the Neck (part 2) over the bottom of the Seat (part 1).
Press firmly until you feel it snap into place. If there is a gap around just half
of where the parts join, press down firmly again in that direction to assure
that the pieces have been joined completely.

Step 3

REMINDER: Ensure that the plastic cap from Step 1 has been removed from
the Cylinder. Leaving this on may damage stool during assembly.
Slip the larger end of the Cylinder (part 3) into the hole on the Base (part 4).
Then, affix the Seat (part 1) and Neck (part 2) assembly to the top
of the Cylinder (part 3).

Step 4

Seat height is adjusted by pressing one of the 2 levers found on either side
of the seat.
The stool's weighted convex base enables you to move freely while sitting
or perching. The weighted base keeps it upright when not in use. A treaded
rubber covering on the weighted base maximizes friction with the floor.
You can perch sit with the stool tilted forward or rock back and forth. This
stool allows motion in every direction. That's why we call it UPLIFT Motion.
The fabric seat provides maximum breathability. This isn't a hot seat after
all, it's made for comfort. Keeps you dry; it's no sweat!
The soft foam padded seat cushion with waterfall edge reduces pressure
points and allows maximum flexibility. There's a reason most stools are round.
®
UPLIFT Motion Stool
CHR454
Part 3
Cylinder
Part 4
Base
CHR454/R02