Flex Chair (set of 2)
CHR467
Package Contents
Seat
qty 2
Note:
Chairs are recommended primarily for indoor use but can be used outdoors for short periods.
1
Base
qty 2
Chair Assembly
A. Place one chair Seat upside down on the edge of a table
B. Align the six attachment holes in the Base and Seat,
C. Tighten each screw with a 5mm Allen Wrench and place
D. Repeat this process for additional chairs.
Interlock Chairs (optional)
Chairs can be interlocked to keep them aligned and
to create rows that are even and consistently spaced.
To interlock chairs:
A. Place the chairs side by side.
B. While standing behind two chairs, lift the left chair and
C. Continue to add chairs to the row in this way.
To Separate Interlocked Chairs:
A. While standing behind the first chair at the left end of
the row, lift the chair to the left up and off the legs of
the chair to the right.
B. Continue to separate chairs.
M6 x 20 Screw
qty 12 (6 per chair)
and place a Base on top of the Seat as shown.
then insert one M6 x 20mm Screw into each hole.
the chair upright on the floor.
place its right-side legs over the top of the left-side legs
of the other.
5mm Allen Wrench
Need help?
Do you have a question about the CHR467 and is the answer not in the manual?
Questions and answers