Devolo Giga Bridge Manual page 39

39 Configuration
Resetting an adapter or removing it from a net-
work
To remove a devolo Giga Bridge adapter from
1
your network, click on Leave G.hn network.
Wait until the LED flashes white and then dis-
2
connect the devolo Giga Bridge adapter from
the mains supply.
Both devolo Giga Bridge adapters have to
be configured identically (SISO or MIMO
mode) in order to establish a connection
with each other.
Be aware that new or reset devolo Giga Bridge
adapters will not be found and integrated
automatically if the existing devolo Giga Bridge
adapters
devolo Giga Bridge adapters back to SISO mode
to enable
devolo Giga Bridge adapters.
G.hn mode
Depending on whether you have connected the
two devolo Giga Bridge adapters via a telephone
or coaxial line, the SISO or MIMO operating modes
are available to you. If you use all four telephone
devolo Giga Bridge
are in MIMO mode.
integration
lines during installation via telephone line, you can
select MIMO mode here.
Operating mode:
MIMO
b
SISO
b
You can find more information on the differ-
ence between SISO and MIMO mode in
Chapter Difference between SISO and
MIMO mode.
Set all
SISO operating mode is set by default.
of new