Devolo Giga Bridge Manual page 20

G.hn Flashing behav-
LED iour
5 White Lights up steady
LED
6 White Flashes at inter-
LED vals of
on/ 3 sec off
7 Red and Flashes at inter-
white vals of
LED on/2 sec. off
8 Red and Flashes at inter-
white vals of
LED red/0.5 sec.
white
* Information about the web interface can be
found in Chapter 4 Configuration.
**Depending on the
devolo Giga Bridge adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface. As soon as the network device
(e.g. computer) connected to the network inter-
Meaning
The connection does not have any issues
and the devolo Giga Bridge adapters
are ready to operate.
The devolo Giga Bridge adapter is in
0.1 sec. standby mode.**
The data transmission rate is not in the
0.1 sec. optimal range (PHY rate below 1 Gbps)
The devolo Giga Bridge adapter is carry-
0.5 sec. ing out a firmware update.
face is switched on again, your devolo Giga Bridge
adapter can also be accessed again.
configuration, a
LED status display
(web interface*)
Can be disabled
Can be disabled
Cannot be disabled
Cannot be disabled
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to 3.3 Pairing – Establishing a G.hn
connection.
devolo Giga Bridge
Introduction 20