Devolo Giga Bridge Manual page 24

After a short time (within three minutes),
the flashing LED becomes a steady white
light. The devolo Giga Bridge adapters
have successfully established a network.
The adapters connected with each other
can now be placed at the desired locations
of use.
Wiring using coaxial
Connect the end of the coaxial cable to the
1
coaxial socket (coax)
devolo Giga Bridge adapters.
Connect the other end of the coaxial cable to
2
the coaxial socket (coax) of the other
devolo Giga Bridge adapter.
Connect both devolo Giga Bridge adapters to
3
an available power socket. The LEDs of both
adapters flash
devolo Giga Bridge network is automatically
set up (pairing).
on one of the
white. A new
After a short time (within three minutes),
the flashing LED becomes a steady white
light. The devolo Giga Bridge adapters
have successfully established a network.
The adapters connected with each other
can now be placed at the desired locations
of use.
Resetting a devolo Giga Bridge adapter or
removing it from a devolo Giga Bridge network
Keep in mind that all settings that have al-
ready been made will be lost!
To remove a devolo Giga Bridge adapter from
1
your devolo Giga Bridge network and success-
fully restore its entire configuration to the fac-
tory defaults, press and hold the reset button
longer than 10 seconds.
Wait until the LED flashes white and then dis-
2
connect the devolo Giga Bridge adapter from
the mains supply, if necessary.
Note: Be aware that
devolo Giga Bridge adapters will not be found
and integrated automatically if the existing
devolo Giga Bridge adapters are in a different
mode. Set all devolo Giga Bridge adapters to the
Initial use 24
new or reset
devolo Giga Bridge