Devolo Giga Bridge Manual page 26

lation displacement terminal has to be used to con-
nect the existing telephone wiring to the G.hn
phone jack of the devolo Giga Bridge. The tele-
phone cable is removed from the demarcation
point and then split and contacted by means of
connection technology involving wire stripping
and soldering or screwing down. A standard net-
work interface is created as a result. Then a classic
network cable (Cat 5e or higher) can be used to es-
tablish a connection to the devolo Giga Bridge
(phone).
Fig. 5: Using LSA, the telephone cable becomes a full-
fledged network interface. The devolo Giga Bridge
can be connected via the network cable (phone) to the
ONT
Note the correct pin assignment:
Pin 4/5 for SISO
b
Pin 4/5 and 3/6 for MIMO
b
Incorrect pin assignment results in wires
from different wire pairs being used. This
can impair the transmission. The wiring in
pairs is correct.
Plug one adapter of the devolo Giga Bridge
1
into an available power socket next to the NT/
ONT.
Connect the adapter of the devolo Giga Bridge
2
using the provided network cable with the NT/
ONT.
Connect the adapter of the devolo Giga Bridge
3
using the telephone line (G.hn phone line
socket, phone) to a connection already in the
wall.
The connection between the NT/ONT and
router over the
completed.
Initial use 26
telephone line is
devolo Giga Bridge