Pairing - Establishing A G.hn Connection - Devolo Giga Bridge Manual

23 Initial use
3.3 Pairing – Establishing a G.hn
connection
devolo Giga Bridge adapters that are in factory de-
fault condition, i.e. have been purchased or suc-
cessfully reset (see Chapter
devolo Giga Bridge adapter or removing it from
a devolo Giga Bridge network), automatically at-
tempt to pair with another devolo Giga Bridge
adapter when reconnected to the mains supply.
Starting up a new devolo Giga Bridge network
For the initial installation, we recommend
setting up (pairing) the adapters in the vicin-
ity of the ONT and using a power strip for
the installation process. When operated
normally,
devolo Giga Bridge should be plugged into
single power sockets at the place of destina-
tion.
devolo Giga Bridge
Resetting a
all adapters of
For an optimal network connection, the
devolo Giga Bridge
operated in the same mode (SISO or MIMO
mode).
For an optimal connection in the network,
the devolo Giga Bridge adapters must be
operated in the same mode (SISO or MIMO
mode).
You can find more information on the differ-
ence between SISO and MIMO mode in
Chapter Difference between SISO and
MIMO mode.
Wiring using a telephone line
Connect one end of the provided network
1
the
cable to the G.hn phone line socket (phone) on
one of the devolo Giga Bridge adapters.
Connect the other end of the provided net-
2
work cable to the G.hn phone line socket
(phone) of the other devolo Giga Bridge
adapter.
Connect both devolo Giga Bridge adapters to
3
an available power socket. The LEDs of both
adapters flash
devolo Giga Bridge network is automatically
set up (pairing).
adapters must be
white. A new