Vitodens 200-W B2HE Operating
Switching the Lightguide On and Off
Depending on the type of boiler, a red illuminated strip
(Lightguide) is displayed at the lower or upper edge of the
control unit during operation.
In the delivered condition, the Lightguide is switched on.
You can switch off the Lightguide.
Meaning of the display:
Lightguide pulsates slowly:
Display is in standby mode.
Lightguide is illuminated constantly:
You are operating the control unit. Every input
operation is confirmed by a brief flashing.
Lightguide flashes quickly:
There is a fault in the system.
Lead Cascade Boiler Only: Switching on the Display
Audio Signal When Buttons are Pressed
Entering Names for Heating Circuits
Tap the following buttons:
1.
2.
"Settings"
3.
"Display setting"
4. "Lightguide on/off"
5.
"ON"
or
"OFF"
6.
to confirm
Note: Faults are shown by flashing lights even if the
Lightguide is switched off.
Tap the following buttons:
1.
2.
"Wake up display"
3. Select and confirm the lag boiler.
With the factory settings, an audio signal is heard when
a button is tapped. You can switch this audio signal
on or off.
Tap the following buttons:
1.
2.
"Settings"
3.
"Buzzer"
4.
"ON"
or
"OFF"
5.
to confirm
You can name all heating circuits individually, e.g.
"Ground floor".
Note: The abbreviations 1, 2, 3, 4 will be retained in the
default display.
Tap the following buttons:
1.
2.
"Settings"
3.
"Rename heating circuits"
4. Required heating circuit, e.g.
5. Type in the required name,
e.g. "Ground floor" (1 to 20 characters).
6.
to confirm
The name assigned to the relevant heating circuit is
shown in the main menu.
Additional Adjustments
"Heating circuit 1"
27