Heating Circuit Selection; Setting The Room Temperature For A Heating Circuit; Switching Central Heating On Or Off (Operating Program) - Viessmann VITODENS 200-W B2HE 85 Operating Instructions Manual

Central Heating

Heating Circuit Selection

Setting the Room Temperature for a Heating Circuit

Switching Central Heating On or Off
20
The heating of your rooms can be split over several
heating circuits if necessary.
E.g., one heating circuit for your home, and one heating
circuit for your office.
In the menu bar, the heating circuits are designated at
the factory as "Heating circuit 1", "Heating circuit 2"
etc. If names have been given to the heating circuits,
the allocated name is shown: See chapter "Entering
names for heating circuits".
For all central heating settings for heating systems
with several heating circuits, first select the heating
circuit that you want to change from the "Heating
circuit" default display.
If you are only operating one heating circuit, this
option is not available.
Tap the following buttons:
1. If applicable, for the "Heating circuit" default display
2. "Heating circuit 1
3. Required heating circuit
Factory settings for the temperature levels
Weather-compensated operation:
Standard room temperature: 68°F (20°C)
Reduced room temperature: 37°F (3°C)
Comfort room temperature: 68°F (20°C)
Constant operation and room temperature-dependent
operation:
Standard supply temperature: 140°F (60°C)
Reduced supply temperature: 68°F (20°C)
Comfort supply temperature: 158°F (70°C)
Setting temperature levels for central heating
Tap the following buttons:
1. If applicable,
"Continuous operation" default display
2. If applicable,
heating circuit
3. for the required value of the relevant temperature
level:
"Reduced"
"Standard"
"Comfort"
4. to confirm
(Operating Program)
For information on the operating programs, see page 14.
Tap the following buttons:
1.
2. "Turn on/off"
3. Tap the required heating circuit or heating zone to
switch it on or off.
4. to confirm
Vitodens 200-W B2HE Operating
" in the menu bar
for the "Heating circuit" or
in the menu bar for the relevant