Vitodens 100-W B1HE/B1KE Operating
Setting the Display Brightness
Switching the "Lightguide" On and Off
Tap the following buttons:
1. Call up the home screen.
2.
3.
for "Settings"
4. OK to confirm
5.
for "Display brightness"
6. OK to confirm
7.
for "Display"
8. OK to confirm
9.
for the selected value
10. OK to confirm
11.
for approx. 4 sec, to exit the menu.
Depending on the type of boiler, a red illuminated strip
(Lightguide) is displayed at the lower or upper edge of the
control unit during operation.
In the delivered condition, the Lightguide is switched on.
You can switch off the Lightguide.
Meaning of the display:
Lightguide pulsates slowly:
Display is in standby mode.
Lightguide is illuminated constantly:
You are operating the control unit. Every input
operation is confirmed by a brief flashing.
Lightguide flashes quickly:
There is a fault in the system.
Tap the following buttons:
1. Call up the home screen.
2.
3.
for "Settings"
4. OK to confirm
5.
for "Display brightness"
6. OK to confirm
7.
for "Lightguide"
8. OK to confirm
9.
for "ON" or "OFF"
10. OK to confirm
11.
for approx. 4 sec, to exit the menu.
Note: Faults are shown by flashing lights even if the
Lightguide is switched off.
Further Adjustments
19