Operating Principles; Screen Displays - Viessmann VITODENS 200-W B2HE 85 Operating Instructions Manual

Wall mounted gas-fired condensing boiler with 7 inch color touchscreen display
Hide thumbs Also See for VITODENS 200-W B2HE 85:
Table of Contents

Advertisement

Vitodens 200-W B2HE Operating

Operating Principles

Screen Displays

Standby display
If the controls have not been operated for some time,
the display initially switches to the standby display.
After a few minutes, the illumination is switched off.
Touchscreen
You can adjust any setting on your system centrally at
the control unit.
The control unit is equipped with a touchscreen. For
settings and to call up information, tap the on-screen
buttons.
Remote control for weather-compensated operation
If remote control units are installed in your rooms, you
can also adjust the settings at the remote control units.
Remote control operating instructions
Status display with Lightguide
Depending on the type of boiler, a red illuminated strip
(Lightguide) is displayed at the lower or upper edge of the
control unit during operation.
Meaning of the display:
Lightguide pulsates slowly:
Display is in standby mode.
Lightguide is illuminated constantly:
You are operating the control unit. Every input
operation is confirmed by a brief flashing.
Lightguide flashes quickly:
There is a fault in the system.
Note: You can switch off the Lightguide. See page 27.
Home screen
The default displays provide access to the most important
settings and checks.
Use
to choose between the following displays:
Heating circuit or Continuous operation
DHW
Dashboard
Cascade status (if available)
For further information regarding the default displays:
See page 12 onwards.
After starting or activating the control unit the home
screen is shown.
With the factory settings, the "Heating circuit" or
"Continuous operation" display is shown as the home
screen. The display depends on the operating mode
(weather-compensated operation, constant (continuous)
operation). You can specify a different display for the
home screen:
Call up the home screen as follows:
Standby display active:
Tap anywhere on the screen.
From the "Main menu":
Tap
.
Note: You can prevent operation of the home screen:
See page 26.
If you do so, you will not be able to make adjustments
on either the home screen or the main menu.
"Panel locked" is displayed.
Operation
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vitodens 200-w b2he 199

Table of Contents