Installing The H-Udi Port Connector On The User System - Renesas Emulator System SH7362 User Manual

1.3

Installing the H-UDI Port Connector on the User System

Table 1.3 shows the recommended H-UDI port connectors for the emulator.
Table 1.3 Recommended H-UDI Port Connectors
Connector Type Number
36-pin connector DX10M-36S
DX10M-36SE,
DX10G1M-36SE
14-pin connector 2514-6002
38-pin connector 2-5767004-2
Note: When designing the 36-pin connector layout on the user board, do not connect any
components under the H-UDI connector. When designing the 14-pin connector layout on
the user board, do not place any components within 3 mm of the H-UDI port connector.
When designing the 38-pin connector layout on the user board, reduce cross-talk noise etc.
by keeping other signal lines out of the region where the H-UDI port connector is situated.
As shown in figure 1.1, an upper limit (5 mm) applies to the heights of components
mounted around the user system connector.
Manufacturer
Hirose Electric Co., Ltd.
Minnesota Mining &
Manufacturing Ltd.
Tyco Electronics AMP K.K.
Specifications
Screw type
Lock-pin type
14-pin straight type
38-pin Mictor type
3