Table of Contents
Advertisement
1.2
Connecting the Emulator with the User System
To connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI port
connector must be installed on the user system to connect the user system interface cable. When
designing the user system, refer to an example of recommended connection between the connector
and the MPU shown in this manual. In addition, read the E10A-USB emulator user's manual and
hardware manual for the related device.
Table 1.2 shows the type number of the emulator, the corresponding connector type, and the use of
AUD function.
Table 1.2 Type Number, AUD Function, and Connector Type
Type Number
HS0005KCU02H
HS0005KCU01H, HS0005KCU02H
HS0005KCU02H
The H-UDI port connector has the 36-pin, 14-pin, and 38-pin types as described below. Use them
according to the purpose of the usage.
1. 36-pin type (with AUD function)
The AUD trace function is supported. A large amount of trace information can be acquired in
realtime. The window trace function is also supported for acquiring memory access in the
specified range (memory access address or memory access data) by tracing.
2. 14-pin type (without AUD function)
The AUD trace function cannot be used because only the H-UDI function is supported. Since
the 14-pin type connector is smaller than the 36-pin type (1/2.5), the size of the area where the
connector is installed on the user system can be reduced.
3. 38-pin type (with AUD function)
The AUD trace function is supported. As well as the 36-pin type, a large amount of trace
information can be acquired in realtime. Since the 38-pin type connector is smaller than the
36-pin type (1/2.5), the size of the area where the connector is installed on the user system can
be reduced. To use the 38-pin type connector, however, an optional cable (HS0005ECK01H)
is required.
2
Connector
36-pin connector
14-pin connector
38-pin connector
AUD Function
Available
Not available
Available
Advertisement
Table of Contents
