Replacement Of Netbay Advanced Connectivity Technology Rcm - IBM Cluster 1350 Installation And Service

Hide thumbs Also See for Cluster 1350:

Table of Contents

4. Verify that the console switch is turned on. After approximately 40 seconds, the

5. Get the IP address of the TFTP server. If using the SolarWinds TFTP server the

6. Right click on Network Neighborhood and select the Properties tab.

7. On the Protocols tab select TCP/IP protocol

8. Select Properties and make note of the IP address.

9. If needed, assign the IP address for the console switch:

Replacement of NetBAY Advanced Connectivity Technology RCM

Detailed removal, replacement, and configuration information for the RCM is

available online at the following URL:

ftp://ftp.pc.ibm.com/pub/pccbbs/pc_servers_pdf/rcm_iug520.pdf

console switch will send out a message reading : Avocent AutoView 1000R/2000R

Ready_Press any key to continue. Press any key to access the AutoView

1000R/2000R main menu.

IP address is shown in the lower right-hand corner of the server's pane.

Otherwise you must extract the IP address using the OS tools.

a. In the terminal emulation window enter 1 to select Network Configuration.

b. Compare the IP address shown for the console switch to the IP address of

the TFTP server. The first three numbers of both IP addresses must be the

same, but the last number must be different. If the console switch IP

address is incorrect type 3 to select IP address and then enter the correct

address.

c. Type 0 to exit the Network Configuration menu and follow the prompts on

the screen to upgrade the FLASH level on the console switch.

Chapter 13. KVM Switch replacement and configuration

Table of Contents