Csm Checks - IBM Cluster 1350 Installation And Service

Adapter device driver not configured: If the device driver is not configured, and
there are no adapter hardware problems reported, go to "Linux" on page 72 to
continue with the problem determination process.

CSM checks

Events not logged or actions not taken: Using the ERRM CLI, monitor the
AnyNodeProcessorsIdleTime condition on specific managed nodes with the
LogEventsAnyTime response while causing arm and rearm events. If arm and rearm
events are not observed at the management server for managed nodes which are
currently up and reachable from the management server, follow problem
determination section in Monitoring HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmadm.html
Differences in node lists: Output from command
CT_CONTACT=<ManagedNodeName> lsrsrc IBM.[Host|FileSystem] when run
on the management node is not the same as when run on the managed node.
Likely configuration or network problem, follow problem determination section in
Monitoring HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmadm.html
netstat output incomplete: The command netstat -an | grep rmc on the
management server does not show ESTABLISHED TCP connections to each
currently managed node which is up. Follow problem determination section in
Monitoring HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmadm.html
RMC not running: The command lssrc -ls ctrmc shows that RMC is not running
on the management server. Follow problem determination section in Monitoring
HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmadm.html
lsrsrc reports errors: The command lsrsrc -ab IBM.[Host|FileSystem]' which
checks that HostRM and FSRM will run on the management server reports errors.
Follow problem determination section in Monitoring HOWTO located at:
http://www-1.ibm.com/servers/eserver/clusters/library/csmadm.html
lsaudrec reports errors: The command lsaudrec which checks that AuditRM will
run on the management server reports errors. Follow problem determination
section in Monitoring HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmadm.html
Predefined conditions not shown: The lscondition and lsresponse commands
when run on the management server do not show pre-defined conditions and
responses. Follow problem determination section in Monitoring HOWTO located
at: http://www-1.ibm.com/servers/eserver/clusters/library/csmadm.html
Commands or file replication fails: CSM commands fail or CFM file replication
fails. Follow problem determination section in Overview HOWTO located at:
http://www-1.ibm.com/servers/eserver/clusters/library/csmadm.html and FAQs,
Hints, and Tips section in Set-Up HOWTO located at: http://www-
1.ibm.com/servers/eserver/clusters/library/csmsetup.html
rpower or rconsole commands fail: CSM rpower and rconsole commands fail.
Follow problem determination in Remote Control HOWTO located at:
http://www-1.ibm.com/servers/eserver/clusters/library/csmremot.html
70
Installation and Service