Environmental Notices; Product Recycling And Disposal - IBM Cluster 1350 Installation And Service

CAUTION:
Removing components from the upper positions in the Enterprise Rack cabinet
improves rack stability during relocation. Follow these general guidelines
whenever you relocate a populated rack cabinet within a room or building:
v Reduce the weight of the rack cabinet by removing equipment starting at the
v If the rack cabinet you are relocating is part of a suite of rack cabinets, detach
v Inspect the route that you plan to take to eliminate potential hazards.
v Verify that the route that you choose can support the weight of the loaded
v Verify that all door openings are at least 760 x 2030 mm (30 x 80 in.)
v Ensure that all devices, shelves, drawers, doors, and cables are secure.
v Ensure that the four leveling pads are raised to their highest position.
v Ensure that there is no stabilizer bracket installed on the rack cabinet.
v Do not use a ramp inclined at more than ten degrees.
v Once the rack cabinet is in the new location, do the following:
If a long distance relocation is required, restore the rack cabinet to the
configuration of the rack cabinet as you received it. Pack the rack cabinet in the
original packaging material, or equivalent. Also, lower the leveling pads to raise
the casters off of the pallet and bolt the rack cabinet to the pallet.
The following is a list of safety notices (in English only) pertaining to hardware
maintenance tasks:

Environmental notices

Product recycling and disposal

This product contains materials such as circuit boards, cables, electromagnetic
compatibility gaskets, and connectors which might contain lead and
top of the rack cabinet. When possible, restore the rack cabinet to the
configuration of the rack cabinet as you received it. If this configuration is not
known, you must do the following:
– Remove all devices in the 32U position and above.
– Ensure that the heaviest devices are installed in the bottom of the rack
cabinet.
– Ensure that there are no empty U-levels between devices installed in the
rack cabinet below the 32U level.
the rack cabinet from the suite.
rack cabinet. Refer to the documentation that comes with your rack cabinet for
the weight of a loaded rack cabinet.
– Lower the four leveling pads.
– Install stabilizer brackets on the rack cabinet.
– If you removed any devices from the rack cabinet, repopulate the rack
cabinet from the lowest position to the highest position.
DANGER notices warn you of conditions or procedures that can result in death
or severe personal injury.
CAUTION notices warn you of conditions or procedures that can cause
personal injury that is neither lethal nor extremely hazardous.
ATTENTION emphasizes certain explanatory information and calls attention to
statements in text, figures, and tables. Attention notices also highlight situations
that could potentially cause damage to the equipment or loss of data.
Safety and environmental notices
xv