Pin Ext. Cap - Renesas Emulation Pod M37641T2-RPD-E User Manual

(2) Pin Ext. Cap

In the factory-setting, the emulation pod processes the pin and does not connect it to the target system.
• When the emulation pod processes the pin (factory-setting)
Set SW8 of the emulation pod to INT side. The connection in the emulation pod is shown in Figure
3.6 below.
Figure 3.6 Connecting pin Ext. Cap (SW8 = INT)
• When Connecting to the target system
Set SW8 of the emulation pod to EXT side. The connection to the target system is shown in Figures
3.7 and 3.8 below.
Figure 3.7 Connecting pin Ext. Cap (SW7 = EXT, SW8 = EXT)
Figure 3.8 Connecting pin Ext. Cap (SW7 = INT, SW8 = EXT)
( 29 / 68 )
Connected to the target
system via the flexible cable
Connected to the target
system via the flexible cable