Renesas Emulation Pod M37641T2-RPD-E User Manual page 29

Table 3.1 Switch settings of the M37641T2-RPD-E
Switch setting
P50
SW1
XCIN
(Factory-setting)
NC
SW2
P51/XCOUT
(Factory-setting)
INT
SW7
EXT
(Factory-setting)
INT
SW8
EXT
(Factory-setting)
NC
SW9
EXT
(Factory-setting)
P50 side
[Using as a port]
When using pin P50/XCIN as a
port, set to this side.
[Using as a sub-clock]
When using P50/XCIN as a sub-
clock and selecting the XCIN
oscillator circuit on the target board,
set to this side.
P51/XCOUT side
Connects pin XCOUT/P51 to the
target system.
EXT side
[Using the USB connector on the
target board]
When connecting pins USB D+ and
USB D- via the flexible cable, set to
this side. With this setting, pins USB
D+ and USB D- are not connected
to the USB connector in the
emulation pod.
INT side
Does not output pin Ext. Cap to the
target system. Pin Ext. Cap is open.
NC side
Does not output the clock (pin
XOUT) to the target system. Pin
XOUT is open.
( 27 / 68 )
Description
XCIN side
[Using as a sub-clock]
When using pin P50/XCIN as a
sub-clock and selecting the XCIN
oscillator circuit OSC-2 in the
emulation pod, set to XCIN side.
NC side
Does not connects pin XCOUT/P51
to the target system. Pin XCOUT/
P51 is open.
INT side
[Using the USB connector in the
emulation pod]
When connecting pins USB D+ and
USB D- to the USB connector in the
emulation pod, set to this side. With
this setting, pins USB D+ and USB
D- are not connected to the flexible
cable.
EXT side
To connect pin Ext. Cap to the
target system, set to this side.
EXT side
Outputs the clock (pin XOUT) to the
target system.