Renesas M16C/62P Group Reference Manual page 92

[data2]
[data3]
Return value If A/D converter was successfully set, RAPI_TRUE is returned; if failed, RAPI_FALSE
is returned.
Functionality A/D converter
Reference __EnableADC, __DestroyADC, __GetADC,
Rev.1.00 2007.11.1
REC10B0002-0100
(Operating Specify one from { RAPI_AD_ON, RAPI_AD_OFF }. The default value is
states set) RAPI_AD_OFF.
Specify one from { RAPI_WITH_SAMPLE_HOLD,
(Conversion
RAPI_WITHOUT_SAMPLE_HOLD }. The default value is
method)
RAPI_WITHOUT_SAMPLE_HOLD.
Specify one from { RAPI_SOFTWARE_TRIGGER,
(Trigger)
RAPI_EXTERNAL_TRIGGER }. The default value is
RAPI_SOFTWARE_TRIGGER.
(External Specify one from { RAPI_ANEX_UNUSED, RAPI_EXTERNAL_OP_AMP }.
Op-Amp The default value is RAPI_ANEX_UNUSED.
Connection)
• Specifiable definition values when repeat sweep mode 1 is used
(RAPI_REPEAT_SWEEP1 specified)
(Input pin) Specify one from { RAPI_P0_GROUP, RAPI_P10_GROUP,
RAPI_P2_GROUP }. The default value is RAPI_P10_GROUP.
(Operating Specify one from { RAPI_FAD, RAPI_FAD2, RAPI_FAD3, RAPI_FAD4,
frequency) RAPI_FAD6, RAPI_FAD12 }. The default value is RAPI_FAD4.
(Resolution) Specify one from { RAPI_10BIT, RAPI_8BIT }. The default value is
RAPI_8BIT.
(Operating Specify one from { RAPI_AD_ON, RAPI_AD_OFF }. The default value is
states set) RAPI_AD_OFF.
Specify one from { RAPI_WITH_SAMPLE_HOLD,
(Conversion
RAPI_WITHOUT_SAMPLE_HOLD }.
method)
The default value is RAPI_WITHOUT_SAMPLE_HOLD.
Specify one from { RAPI_SOFTWARE_TRIGGER,
(Trigger)
RAPI_EXTERNAL_TRIGGER }.
The default value is RAPI_SOFTWARE_TRIGGER.
(External Specify one from { RAPI_ANEX_UNUSED, RAPI_EXTERNAL_OP_AMP }.
Op-Amp The default value is RAPI_ANEX_UNUSED.
Connection)
The set value differs with the A/D conversion mode used.
One-shot mode
Repeat mode
Single sweep mode
Repeat sweep mode 0
Repeat sweep mode1
Specify the interrupt priority level (0–7) to be set in the interrupt control register.
Specify 1.
Specify 2, 4, 6, or 8.
Specify 1, 2, 3, or 4.
__GetADCAll
90