2. Important Safety Instructions
The safety alert symbols below indicate a personal
safety
or
READ THESE INSTRUCTIONS CAREFULLY.
This automatic shutter opener is designed and tested to
offer safe service provided it is installed and operated in
strict accordance with the following safety rules. Failure
to comply with the following instructions may result in
death, serious personal injury or property damage.
WARNING!
ELECTROCUTION!
4
Axess Pro Series 3000
property
damage
•
The shutter may operate unexpectedly, therefore do not allow
anything to stay in the path of the door.
For Safety protection, a Safety Beam must be fitted with logic
•
console. Failure to comply will void the warranty and may result in
serious personal injury and/or property damage .
•
The drive must not be used with a shutter incorporating a wicket door,
unless the drive cannot be operated with the wicket door open.
•
The drive is intended to be installed at least 2.5m above the floor.
•
DO NOT allow children to operate the opener. Any device that can
operate the opener, make sure it is out of reach of children and that
the doorway is in full view at all times. Serious personal injury and/or
property damage can result from failure to follow this warning.
When using auto close mode, a Safety (Photo Electric) Beam must
•
be fitted correctly and tested for operation at regular intervals.
Extreme caution is recommended when using auto close mode.
All safety rules must be followed.
•
Place opener in protected area so that it does not get wet.
•
Do not spray with water .
•
Disconnect the power cord from mains power before making any
repairs or removing covers. Only experienced service personnel
should remove covers from the opener.
If the power supply cord is damaged, it must be replaced by an
•
Automatic Technology service agent or suitably qualified person.
•
Electrical wiring must be compliance with the local building an
electrical codes.
Owner Installation Instructions
instruction
exists.
Need help?
Do you have a question about the Axess Pro Series and is the answer not in the manual?