Operation Method Of The M3S-Ufla32R; Startup; Exit; Operation Outline Of The M3S-Ufla32R - Renesas M3S-UFLA32R User Manual

4. Operation Method of the M3S-UFLA32R

4.1 Startup

Double-click the icon after the M3S-UFLA32R setup is completed.

4.2 Exit

Choose [Exit(X)] from [File(F)] menu.

4.3 Operation Outline of the M3S-UFLA32R

To write to the flash memory, perform the following steps.
1) Connecting Host PC to Target Board
•Connect D-Sub 9 pin connector of the MF-TEN-NINE cable to COM1 of the host PC.
•Connect MF-TEN-NINE cable to the interface cable.
•Connect IC clip of the interface cable to the target board by referring to Table 4.3.1.
Connect to
COM1 of the
Host PC
Figure 4.3.1 Connection Diagram
Table 4.3.1 Connecting Interface Cable to the Target Board
Interface Cable
IC Clip Color
Red
Blue
Yellow
Black
Green
2) Setting for FP Pin, MOD0 Pin, and MOD1 Pin
Set FP pin of the target board to "H," MOD0 pin to "H," and MOD1 pin to "L," respectively.
For setting procedure, refer to respective board manuals.
3) Power to the Target Board
Start power supply to the target board.
REJ10B0239-0140/Rev.1.40
MF-TEN-NINE Cable
Destination of the Target Board Connection
IC Clip Pin Name
VCC VCCE power supply
SCLK P87 pin
RXD P86 pin (RXD1)
GND GND pin
TXD P85 pin (TXD1)
UART Flash Memory Programming Utility
Interface Cable
Mar. 2007
M3S-UFLA32R
Target Board
Page 6 of 30