Checking The Software Configuration - Sun Microsystems SPARC Series Service Manual

Because the types and versions of installed software and firmware vary depending
on the system, they need to be checked.
The software configuration and the version can be checked in the Solaris OS. For
■
details, see documents of the Solaris OS.
To check software and firmware configuration information, you can use the
commands listed in
authority by the system administrator.
To check the firmware configuration and version, use XSCF shell commands from
the maintenance terminal.
Commands for Checking the Software and Firmware Configurations
TABLE 3-2
Command Description
Displays system configuration information and Solaris OS patch information.
showrev
Outputs current system information.
uname
Outputs current firmware version information.
version
Outputs information on the components mounted on the server.
showhardconf
Displays the status of a component. This command is used only when a faulty
showstatus
component is checked.
Displays XSB information. It can display information on an XSB that belongs to the
showboards
specified domain and information on all XSBs mounted. An XSB combines hardware
resources on physical system boards. The M3000 server consists of a single physical
system board (Uni-XSB).
Displays the configuration information of a domain (hardware resource information).
showdcl
Displays the setting information of a device.
showfru
For details, see the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User's Guide.
3.3.2.1

Checking the Software Configuration

The following procedure can be used to check the software configuration from the
domain console.
●
Type showrev.
# showrev
The showrev command displays system configuration information on the screen.
3-6 SPARC Enterprise M3000 Server Service Manual • January 2009
from the maintenance terminal if you are granted user
TABLE 3-2