Table of Contents
Advertisement
8.4 Update and Confirm Configuration
1. After entering the correct information for all fields press Apply. You
should receive a message confirming the configuration at the top of
the screen.
2. Programming of the SkyEcho is complete.
computer or mobile device from the Wi-Fi hotspot.
9 Normal Operation
9.1 Battery Pack / Charging
The integrated battery pack needs to be fully charged before use.
Connect the USB-C cable to the connector on the bottom of the SkyEcho in
order to charge the battery. The BLUE LED will remain lit during charging,
and will extinguish when the battery is fully charged. Note: It can take up to
12 hours to completely recharge a fully discharged battery.
9.2 Power On/Off
Press and hold the momentary power switch for approximately 3 seconds
to power the SkyEcho on.
Press and hold the momentary power switch for approximately 3 seconds
to power the SkyEcho off.
9.3 Indicators
There are a 3 LEDs visible through the top cover of SkyEcho.
LED
BAT
BAT
BAT
BAT
UAV-1002156-001
ECCN 7A994
REV M
Color
Blue
Red
Yellow
Green
You can disconnect your
On
Battery Charging
Battery Low (<33%)
Battery 33%-66%
Battery > 66%
Page
27 | 35
Advertisement
Table of Contents
