Advertisement
Quick Links
Advertisement
Related Manuals for uAvionix Ping2020i
Summary of Contents for uAvionix Ping2020i
- Page 1 Ping2020i Transceiver Q U I C K S T A R T G U I D E...
- Page 2 Mount The ping2020i GPS antenna requires a clear view of the sky for proper operation. Avoid placing the device directly under props or near features that could ‘shadow’ or block the GPS antenna during flight. Avoid installing the ping2020i under any signal blocking materials such as carbon fiber.
- Page 3 Place the antenna in a location that will be least obstructed by the aircraft during normal flight. to ping2020i. Connect the free end of Connect power harness the harness to a 3S battery or appropriate aircraft power source.
- Page 4 Install Install the uAvionix Ping App from the Apple App Store or Google Play. Search for or use the QR codes uAvionix Ping Installer below. Connect the using the provided ping Programmer ping2020i cable. The 5 pin connector should be connected JST ZHR-5-4 pin to the transceiver.
- Page 5 Join your mobile device to the wireless network named using the procedure for your device. If a WPA Ping-XXXX passphrase is required enter The process for iOS uavionix. is shown below. Go to Wi-Fi, and verify Settings > Wi-Fi is turned on.
- Page 6 Configure Launch the application and complete the fields as uAvionix Ping required for your device/aircraft. Choose Ping2020 Selected Device Type: This setting controls device transmit Control: functions. The selections available will depend on the device type selected. Transceiver selections include:...
- Page 7 Verify for your aircraft. A GPS fix is not necessary for programming but is required to monitor latitude longitude and GPS altitude. power from Disconnect ping2020i Disconnect ping Programmer from ping2020i. will not transmit ping2020i if the ping Programmer attached.
- Page 8 Set the ADSB_ENABLE parameter to 1. When ADS-B traffic is received the green LED will flash and the traffic should appear on the Mission Planner map. For a full list of available Arudpilot parameters visit http://ardupilot.org/ For additional support: uavionix.com/support...
- Page 9 Install Install the uAvionix Ping App from the Apple App Store or Google Play. Search for or use the QR codes uAvionix Ping Installer below. Connect the using the provided ping Programmer ping2020i cable. The 5 pin connector should be connected JST ZHR-5-4 pin to the transceiver.