Related Manuals for uAvionix Ping1090
Summary of Contents for uAvionix Ping1090
- Page 1 Brand Logo Specs (REV D) 20160329 Logo font: Helvetica Neue LT Std 75 Bold = PANTONE P 48-16 C (OR EQUIVALENT) = PANTONE P 179-11 C (OR EQUIVALENT) 1090 uAvionix Ping1090 ADS-B Transceiver Q U I C K S T A R T G U I D E...
- Page 2 Install Install the uAvionix Ping App from the Apple App Store or Google Play. Search for uAvionix Ping Installer or use the QR codes below. Connect the pingUSB FYXnav using the provided JST ZHR-5 cable. pingUSB Micro-USB cable. Connect to a power source using a...
- Page 3 Join Join your mobile device to the wireless network named Ping-XXXX using the procedure for your device. The WPA uavionix. passphrase is The process for iOS is shown below. Go to Settings > Wi-Fi, and verify Wi-Fi is turned on.
- Page 4 Configure Launch the uAvionix Ping application and complete the fields as required for your device/aircraft. Selected Device Type: Choose Ping1090 Control: This setting controls device transmit functions. The selections available will depend on the device type selected. Transceiver selections include:...
- Page 5 Update After completing all data fields tap the Update button. You should receive the Device Configured message, Monitor. Verify all fields are correct for your aircraft. The monitor fields will only populate when FYXNav has a GPS fix. A GPS fix is indicated by a flashing red LED.
- Page 6 Mount Prior to mounting confirm all cable lengths will be sufficient to reach power, autopilot and FYXnav GPS. Mount ping1090 to a suitable flat surface double-sided mounting using the provided tape. Affix mounting tape to the label side of the transceiver and secure to the aircraft...
- Page 7 Connect Connect remaining 5 pin connector FYXNav ping1090. from Connect antenna ping1090 The antenna should be mounted in a vertical orientation using the provided double sided mounting foam. Connect power harness to a 3S battery or appropriate aircraft power source.
- Page 8 Set the ADSB-ENABLE parameter to 1. When ADS-B traffic is received the green LED will flash and the traffic should appear on the Mission Planner map. For a full list of available Arudpilot parameters visit http://ardupilot.org/ uavionix.com/support For additional support:...