Related Manuals for uAvionix Ping1090i
Summary of Contents for uAvionix Ping1090i
- Page 1 Brand Logo Specs (REV D) 20160329 Logo font: Helvetica Neue LT Std 75 Bold = PANTONE P 48-16 C (OR EQUIVALENT) = PANTONE P 179-11 C (OR EQUIVALENT) 1090i uAvionix Ping1090i Transceiver Q U I C K S T A R T G U I D E...
- Page 2 Install Install the uAvionix Ping App from the Apple App Store or Google Play. Search for uAvionix Ping Installer or use the QR codes below. Connect the pingUSB ping1090i using the provided JST ZHR-5 cable. pingUSB Micro-USB cable. Connect to a power source using a...
- Page 3 Join Join your mobile device to the wireless network named Ping-XXXX using the procedure for your device. If a WPA uavionix. passphrase is required enter The process for iOS is shown below. Go to Settings > Wi-Fi, and verify Wi-Fi is turned on.
- Page 4 Configure Launch the uAvionix Ping application and complete the fields as required for your device/aircraft. Selected Device Type: Choose ping1090 Control: This setting controls device transmit functions. The selections available will depend on the device type selected. Transceiver selections include:...
- Page 5 You should receive the Device Configured message, Monitor. Verify all fields are correct for your aircraft. A GPS fix is not necessary for programming but is required to monitor latitude longitude and GPS altitude. Disconnect power from pingUSB. Disconnect ping1090i from pingUSB.
- Page 6 Mount The ping1090i GPS antenna requires a clear view of the sky for proper operation. Avoid placing the device directly under props or near features that could ‘shadow’ or block the GPS antenna during flight. Avoid installing the ping1090i under any signal blocking materials such as carbon fiber.
- Page 7 Place the antenna in a location that will be least obstructed by the aircraft during normal flight. Connect power harness to ping1090i. Connect the free end of the harness to a 3S battery or appropriate aircraft power source.
- Page 8 Set the ADSB_ENABLE parameter to 1. When ADS-B traffic is received the green LED will flash and the traffic should appear on the Mission Planner map. For a full list of available Arudpilot parameters visit http://ardupilot.org/ uavionix.com/support For additional support:...