Table of Contents
Advertisement
A configuration page similar to the following should load:
For proper operation the following parameters must be configured:
• 1090ES Transmit
• Receiver Mode
• ICAO Address (hex)
• Callsign
• If FLARM fitted: Enter FLARM ID
(hex). Select FLARM filter
• If transmitting ADS-B: Select
ADS-B Ownship filter
• Emitter Category
• VFR Squawk (country specific)
After configuration of your parameters click on "Apply" to save.
8.3.2 1090ES Transmit
This setting configures SkyEcho for transmission. Select the checkbox to
enable transmission if allowed in your operating location.
UAV-1002156-001
ECCN 7A994
REV M
• ADS-B In Capability: Select
1090ES
• Air/Ground Threshold Speed
(V
)
S0
• Aircraft Length
• Aircraft Width
• Lateral GPS Offset
• Longitudinal GPS Offset
• SDA
Page
20 | 35
Advertisement
Table of Contents
