Primaty-Secondary Set Up | Power Cord Daisy Chain - ADJ Startec Series User Manual

This function will allow you to link up to 16 units together and operate without a controller. In a
Primary-Secondary set up, one unit will act as the controlling unit and the others will react to the
controlling unit's programs. Any unit can act as a Primary or as a Secondary.
1. Using approved DMX data cables, daisy chain your units together via the XLR connectors on the
rear panel of the each unit. Remember that the male XLR connector is the input and the female
XLR connector is the output. The first unit in the chain (primary) will use the female XLR connec-
tor only, and the last unit in the chain will use the male XLR connector only. For longer cable runs,
it is recommended to use a terminator on the last fixture.
2. On the Primary unit press the MENU button until "SEcd" is displayed, and press ENTER. Use the
UP and DOWN buttons to scroll to the "PRI" setting and press ENTER.
3. After setting the Primary unit to the primary setting, find and set your desired operating mode.
4. On each secondary unit, press the MENU button until "SEcd" is displayed, and press ENTER.
Choose either "SEC1" or "SEC2" and press ENTER.
5. The secondary units will now follow the Primary.
This feature allows the user to connect the fixtures to one another using the IEC input and output
sockets.
The maximum number of units that can be connected in this manner is 10 fixtures. Once this
number has been reached, a new power outlet is required to accommodate any additional
units.
All connected fixtures must be of the same make and model type. Do NOT mix and match fix-
tures models!
PRIMARY-SECONDARY SET UP
POWER CORD DAISY CHAIN
19