ADJ Startec Series User Manual page 16

System Menu: When making adjustments, press ENTER to confirm your setup, then press and
hold the MENU button for at least 3 seconds. To exit without making any adjustments, press
the MENU button. The display will lock after 30 seconds after 30 seconds of inactivity, and can
be unlocked by pressing the MENU button for 3 seconds.
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is displayed, then press ENTER.
2. The currently selected address will now be displayed and flashing. Press the UP or DOWN but-
tons to scroll to your desired address. Press ENTER to set your desired DMX address.
CHND - This will let select your desired DMX channel mode.
1. Press the MENU button until "CHND" is displayed, then press ENTER. The currently selected
DMX channel mode will be displayed.
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to
confim and exit.
SHND - Show modes 0-7 (Factory programs).
1. Press the MENU button until "SHND" is displayed, then press ENTER.
2. "Sh X" will now be displayed, where "X" represents a number between 0-7. Shows 1-7 are fac-
tory programs, while show "0" is random mode. Use the UP or DOWN buttons to scroll to your
desired show.
3. When you have found your desired show, press ENTER, then press and hold the MENU button
for at least 3 seconds to activate. After you have set your desired show, it can be changed at any
time using the UP or DOWN buttons.
UVSP - UV activation/speed control.
1. Press the MENU button until "UVSP" is displayed, then press ENTER.
2. The display will show either "FAST" or "SLOW". Use the UP and DOWN buttons to highlight your
selection.
3. Press ENTER to confirm.
SEcd - This will let you set unit as a primary or secondary in a primary/secondary configura-
tion.
1. Press the MENU button until "SEcd" is displayed, then press ENTER. Either "PRI", "SEC1", or
"SEC2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, then press ENTER to con-
firm.
NOTE: When the secondary fixture is set to "SEC2", its movement will be set to contrast with the
movement of the primary fixture.
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, then press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SYSTEM MENU
16