ADJ Startec Series User Manual page 17

SOSE - In this mode you can adjust the sound sensitivity.
1. Press the MENU button until "SOSE" is displayed, then press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity. 0 is the least sensitive, and 100 is the most sensitive.
3. When you have found your desired setting, press ENTER to confirm.
DNST - This mode defines how the fixture will behave in the event that the DMX signal is lost
or interrupted, or the mode the the unit will return to when it is powered up.
1. Press the MENU button until "DNST" is displayed, and either "PRI", "BLND", or "LAST" will be
displayed beneath, depending on the currently selected option.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to select
the desired operating mode.
• LAST - If the DMX signal is lost, the fixture will stay in the last DMX setting. If power is applied
and this mode is set, the unit will automatically go into the last DMX set up.
• MASL (Primary Secondary) - If the DMX signal is lost or power is applied, the unit will auto-
matically go into Primary Secondary mode and run a built-in show.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
3. Press ENTER to confirm your desired set up.
LED - With this function, the user can set the LED display to turn off after 10 seconds of inac-
tivity.
1. Press the MENU button until "LED" is displayed, then press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
keep the LED display on at all times, or "OFF" to switch to have the LED display switch off after
10 seconds of inactivity.
TEST - This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, then press ENTER.
2. The fixture will now run a self test.
DISP - This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, then press ENTER.
2. Press ENTER to "flip" the display. Press ENTER to "flip" it again.
3. Press ENTER to confirm. To make you LED display reappear again press any button.
FHRS - Display the running time of the unit.
1. Press the MENU button until "FHRS" is displayed, then press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
VER - Use this function to display the Software version of the unit.
1. Press the either the MENU button until "VER" is displayed, then press ENTER.
2. The display will show the software version.
RSET - This function will reset the unit.
Press the MENU button until "RSET" is displayed. Press the ENTER button and the unit will reset
itself.
SYSTEM MENU
17