Table of Contents
Advertisement
Installation
Installation of workstation
Preparing the workstation table (option)
The workstation table (option), a motorized vertically adjustable table, shall be used to put
the workstation components to the Opdima? system on. The vertical adjustment device
includes a transformer, which is not mounted on delivery.
CAUTION
Fig. 18 Transformer
1.
2.
3.
Siemens-Elema AB
Solna, Sweden
The workstation table must not be overloaded.
Any additional equipment is added at own risk and the maximum
load of 80 kg must not be exceeded.
3
Handschalter
5
Remove the screws on the underside of the tabletop and use them when
mounting the transformer (1/Fig. 18).
Place the transformer so that the connectors are turned to the column.
Connect the cable from the control unit (2/Fig. 18) for the vertically adjustment to
the connector marked "Handschalter" (3/Fig. 18).
Connect the cable from the motor (4/Fig. 18) for the vertically adjustment to the
other connector (5/Fig. 18).
Register 3
1
SPB7-230.033.10
Rev. 03
08.02
2
4
Page 17 of 26
SPS-UD
5 - 17
5
5
Opdima?
Installation
Advertisement
Table of Contents
