Operating The Controls - Waring WFP14SK Manual

Disassembly when removing the S-blade
• Remove the work bowl from the unit by rotating clockwise (left) to
disengage the tabs on the bottom of the bowl platform from the
work bowl. When the bowl handle is on the left (about 7 o'clock
position), you can gently lift the bowl straight up and out.
It is recommended that you remove the bowl from the
motor base before you remove the S-blade.
• To remove the blade, keep a slight downward pressure on the top
of the center hub of the blade while removing the bowl from the
motor base. This will form a seal to prevent food particles from
spilling into the center tube of the bowl and onto the motor base
or the work surface. REMOVE ALL FOOD AND LIQUID BEFORE
REMOVING S-BLADE, OR THE BOWL WILL LEAK. Then remove
the S-blade from the bowl. Handle the S-blade with caution; the
blades are extremely sharp.
Disassembly when removing an accessory disc
• Do not remove the work bowl until the accessory disc is removed.
• To remove an accessory disc, place your fingers on the outer edge
of two opposite sides of the disc and lift. The disc should remove
cleanly. To remove the detachable stem, hold the disc in one hand
with the stem facing away from your hand. Be careful not to scrape
your hand on any sharp edges; depress the release switch with
your thumb and rotate counterclockwise.
• Remove the work bowl from the unit by rotating clockwise to
disengage the tabs on the bottom of the bowl platform from the
work bowl. When the bowl handle is on the left (about 7 o'clock
position), you can gently lift the bowl straight up and out.

OPERATING THE CONTROLS

• Plug the machine into an electrical outlet. The outlet must be 230V
(50Hz).
• There are two control levers located on the base of the machine.
They are on the front and give you fingertip control of processing.
They are large enough to find easily in case of emergency.
The two controls are: ON ( )
How they work:
OFF-PULSE (
ON ( ): Press the lever down to start
the motor.
11
, )