Operating The Controls - Waring WFP11S Operation Manual

you fingertip control of processing. They are large enough to find easily in case of emergency.
The two controls are:
How they work:
How to Use
Continuous use
For continuous processing, use the ON lever, which is located on the left.
Pulsing
The pulsing function is intended for use with the S-blade in the work bowl.
motor runs as long as you hold the lever down; it stops when you release the lever.
lever down. You control the frequency of pulses by the rate at which you press the lever. The interval
between pulses must be long enough to allow everything in the work bowl to fall to the bottom.
to any texture or consistency you want, from coarse to fine.
parts. Then proceed with continuous use after the pieces are broken up and easier to process.
control pulses. It is less efficient and could damage the machine.
Turning off
Always turn the machine off with the PULSE/OFF lever and wait until the blade or disc comes to
a complete stop before removing the pusher assembly. The motor stops within seconds after the
machine is turned off.
10
1.800.561.8187

OPERATING THE CONTROLS

ON
PULSE/OFF
ON: Press the lever down to start the motor.
PULSE/OFF: To turn the motor off, press the lever down and release.
To pulse the motor, press the PULSE/OFF lever down, then release. The
motor will run as long as you hold the lever down; it stops when you release
the lever. Try it a few times.
www.
information@itm.com
.com