Operating The Controls - Waring WFP16SC Manual

OPERATING THE CONTROLS

• Plug the machine into an electrical outlet. The outlet must be
120V, 60Hz.
The base unit features three control buttons:
ON, OFF and PULSE.
How they work: ON:
HOW TO USE
Continuous use
For continuous processing, use the ON button which is located in
the middle of the control panel..
Pulsing
• For rapid ON/OFF operation, use the PULSE button. The motor
runs as long as you hold the button down and stops when you
release the button.
• You control the duration of each pulse by the amount of time
you hold the button down. You control the frequency of pulses
by the rate at which you press the button.
• Pulsing gives you greater control over consistency when
chopping, blending and mixing.
• Pulsing is also useful in processing hard foods. Pulse the food
a few times to break it up into smaller parts. Then proceed with
continuous use after the pieces are broken up and easier to
process.
• Always use the PULSE button for pulsing. Never move the
bowl and cover assembly on or off to control pulses. It is less
efficient and could damage the machine.
Press the ON button to start the motor.
OFF: Press the OFF button to stop the motor.
PULSE: To pulse the motor, press the PULSE
button down, then release. The motor
will run as long as you hold the button
down and stops when you release the
button.
13