Operating The Controls - Waring VCM1000SK Instruction Manual

tabs are clear of the groove in the tower. When you rotate the chute, you will
also disengage the bowls locking slots from the locking tabs on the motor
base platform.
• When the chute is in the 4 o'clock position, you can lift the cover off the
chute. Remember to rotate the cover lock to the open position before
removing the cover.
• Remove the large food pusher from the feed tube. Remove the small pusher
from the large pusher.
• To remove an accessory disc from the continuous feed chute, pick up disk by
holding the disk firmly between both hands, and lift it straight up and off the
drive shaft. Be careful not to touch the blades, as they are extremely sharp.
• To remove dicing assembly, follow steps above. Rotate slicing disc
counterclockwise and lift by two fingers under each side of the disc and lift it
straight up. Hold dicing grid, lift straight up and remove from food processor.
• Remove the continuous feed chute from the motor base. If the chute is
pointing in the 4 o'clock position, just lift it up. If not, rotate clockwise to
disengage the tabs on the bottom of the bowl platform (motor base) from the
slots on the bottom of the continuous feed chute.
• Plug the machine into an electrical outlet. The outlet must be 230 volts.
• There are two control paddles (levers) located on the base of the machine
that give you fingertip control of processing and are large enough to find
easily in case of emergency.
The two controls are: ON ( )
How they work:
There are 2 LED's on front of unit. When unit is plugged in, Red LED will
illuminate. When unit is in use Green LED will illuminate.
Press the PULSE/OFF (
The motor will run as long as you hold the lever down; it stops when you
release the lever. Try it a few times.
How to Use:
Continuous Use
For continuous processing, use the ON ( ) lever, which is located on the left.

OPERATING THE CONTROLS

PULSE/OFF (
ON ( ) : Press the paddle down to start the motor.
PULSE/OFF (
release to turn the motor off.
) paddle down, then release, to pulse the motor.
7
)
) : Press the paddle down and