Table of Contents
Advertisement
IMS-4000 Manual
Audible Alarm Notification
The ConsoleView Software can optionally beep or play a custom Wave file whenever an alarm is
detected. To utilize this feature, click File, then Options from the main menu. Under the Alarm
Notification section select Audible Alarm Notification. Next, select either System Beep or Play
Wave. If you selected Play Wave, then you must select the Wave file to be played. Click on the
speaker button to choose a Wave file. After you've made your choice, you can preview it by click-
ing the Play button. See sample screen below:
E-Mail Setup and Two-Way E-Mail Commands
The IMS-4000 can send alarm messages via e-mail using SMTP as well as respond to commands
via e-mail. See the Two-Way E-mail section for more information on sending commands.
To set up the e-mail parameters right click on the Host name and select Network Settings. Select
the Email Settings tab to see the following screen:
To have the unit send e-mail, you need to set the SMTP Server name and the Return e-mail Address,
Username (if required) and Password (if required). To have the unit respond to Two-Way e-mail
commands you must also set the POP Server name, e-mail account Username & Password, and the
Mail Check Interval.
SMTP Error messages
If your e-mail settings are incomplete or incorrect there are some messages that will appear in the
Event History log which may be helpful.
The "Invalid Configuration" message will appear if you don't have both the SMTP Server name
and Return Address programmed. These are the minimum programming requirements to send e-
mail. If you have at least these two items programmed and the IMS-4000 is unable to deliver the
message, then you will get the message "SMTP Server not Responding," which essentially means
that you have one or more of the following problems:
72
Figure 45: Alarm Notification screen
Figure 46: E-mail Settings tab
Advertisement
Table of Contents
