Configure Ip Alarms; Record And Assign Voice Messages - Phonetics Sensaphone IMS-4000 User Manual

up alarm contact information, right-click on the profile name and select Add New Contact. You can
have up to eight contacts per user. The User Profile screen is shown below:

Configure IP Alarms

Program the IP addresses for each network device you want to monitor. Expand the Host menu by
clicking the plus sign next to the name of your host. Next, right-click on IP Alarms and select Add
New IP Alarm. Enter the information to configure the network device you wish to monitor. Be
sure to enable the alarm. The IMS unit will ping/connect to the IP address and port you select about
once per minute. The IP Alarm programming screen is shown below:

Record and Assign Voice Messages

Custom voice messages can be used to identify your IMS Hosts/Nodes, PowerGates, Input sen-
sors, IP alarms, and PowerGate outlets. Voice messages must first be recorded on your computer
and then uploaded to the IMS Host. Use the CustomVoice Manager screen to record and upload
your voice messages. To access the CustomVoice Manager screen, expand the Host menu and select
Voice. Note that Voice messages should be recorded at 8Khz, 8bit, mono, to keep the file size
small. See the detailed section on Recording and Uploading Voice Messages later in the manual
for more information. Voice messages are assigned to elements of your IMS unit on the respective
screens as listed below:
IMS Host Identification message
IMS Node Identification message
Input Sensor message
IP Alarms message
PowerGate messages
Figure 3: User Profile
Figure 4: IP Alarm Setup screen
- Host Unit Properties Screen
- Node Unit Properties Screen
- Input Channel Setup Screen
- IP Alarm Setup Screen
- PowerGate Setup Screen
Chapter 2: Software
41