Phonetics Sensaphone IMS-4000 User Manual page 50

IMS-4000 Manual
Set up the parameters for your environmental input on this screen.
Name: Enter a name which describes what the sensor is monitoring. (ex: Mail Server, Data
Center Rack #3, ...)
Type: The sensor type is determined automatically when the sensor is plugged into the host or node.
Status: The status indicates if the sensor is presently within alarm limits. For devices such as
Water Sensors or Smoke Detectors a Normal condition indicates that there is no water or smoke
detected.
In Use: This indicates that a valid sensor is plugged into the channel.
Enabled: This indicates if the channel is currently enabled for alarm monitoring. If it is disabled,
the IMS-4000 will not send alarm messages. A channel can be enabled or disabled based on a 7-
day + holiday time schedule.
Schedule: Click this button to bring up the Edit Schedule screen. This screen allows you to
set times when the channel is enabled or disabled. The blue line indicates days/times when the
channel is enabled.
The schedule example above enables the sensor Mon-Fri 8AM to 5PM.
Editing the schedule:
• Click on the All button in the top left corner of the grid to enable/disable the entire week.
• Click on the day buttons down the left side of the grid to enable/disable entire days
• Click on the hour buttons across the top of the grid to enable/disable entire hours
• Drag the mouse over portions of the grid to enable/disable specific hours/days
50
Figure 17: Channel Setup screen
Figure 18: Sensor Schedule screen