Table of Contents
Advertisement
IMS-4000 Manual
Installation
This section provides information on:
n Operating environment
n Rack, wall, and tabletop installation
Parts Required
Phillips
Screwdriver
*For additional right-angle power input cables, order part # IMS-4413.
Operating Environment
Before you install the IMS-4302 PowerGate2 be sure that your operating environment meets the
physical requirements of the equipment.
Operating Temperature: 32º –122º Fahrenheit (0º – 50º C)
Humidity:
Power:
Rack Requirements:
Tabletop requirements:
Rack Mount Installation
The IMS-4302 PowerGate2 can be rack mounted using the included rack mount brackets. Follow
the steps below:
1) Attach the rack-mount brackets to the PowerGate2 with a Phillips screwdriver.
2) Attach the unit to the equipment rack using two pan-head screws per side. Tighten the
screws with a Phillips screwdriver.
3) Plug the power cord into a 120VAC outlet.
100
9 pin F/F null
modem cable
5 – 90 %RH, non-condensing
120VAC 60 Hz outlet within 6'
Multiple 15A 120VAC outlets for powering equipment
Standard 19' equipment rack with supplied mounting bracket
hardware. Requires 1.0 EIA rack mount space.
Flat area which can support an enclosure 17" wide by 10" deep by 2"
high.
Figure 3: Rack-mounted PowerGate2 Unit
Right-angle input
power cable (1 included)*
Advertisement
Table of Contents
