Table of Contents
Advertisement
IMS-4860 Door Switch
Installation Instructions
Introduction
The IMS-4000 Door Switch with bridge enables your
IMS-4000 to detect if any unauthorized entry or intru-
sion has occurred. The bridge may be mounted either
on a wall or rest on the floor. The switch is mounted to
doors or windows you wish to monitor. The electrical
connection between the bridge and IMS-4000 is made
via RJ-45 patch cable.
Package Contents
(1) Door Switch with mounting hardware
(1) IMS-4860 bridge
(1) 25ʹ accessory wire
g u r e 1 : D o o r s w i t c h m o u n t i n g
Mounting the Door Switch
The door switch is usually installed to function in a normally closed position when the door (or
window or other portal) on which it is mounted is closed. The complete assembly is of two parts: a
magnet in a plastic housing, and a sensor switch with screw terminals in another plastic housing.
Mount the switch by fastening it to the non-moving frame surrounding the door or window. Use
either mounting screws or the adhesive foam tape attached to the switch segments. Fasten the mag-
net near the edge of the movable sash or door. Position the magnet housing no more than
the switch and tighten mounting screws. Use the spacer bar (included) if needed for alignment.
Chapter 7: IMS-4000 Sensors
1
/
" from
8
137
Advertisement
Table of Contents
