Alarm Response Via The Powergate, Powergate2, Or Camera; Powergate; Camera Snapshots On Alarm - Phonetics Sensaphone IMS-4000 User Manual

Infrastructure monitoring system

Table of Contents

IMS-4000 Manual

Alarm Response via the PowerGate, PowerGate2, or Camera

When an alarm occurs, you can have PowerGate or PowerGate2 outlets automatically turn ON,

turn OFF, or CYCLE power to a device. Cycling will switch an outlet OFF for 10 seconds and

then switch it back ON. To set up a PowerGate, click the Alarm Response button on the Channel

Setup Screen. A sample Alarm Response screen is shown below.

Select Response Type: Choose "PowerGate."

PowerGate: Choose the specific PowerGate you're programming.

Outlet: Choose the PowerGate outlet you want to program for alarm response.

New State: Select the action you want to have occur: On, Off, Cycle.

Click the Add button to add this response to the list of current responses; click Delete to remove an

action. Repeat for as many outlets as you wish to program.

Camera images may be sent to one or more users when an Environmental or IP alarm occurs. Up

to four alarm responses (PowerGate or Camera Snapshot) may be programmed per input. To con-

figure this feature choose Alarm Response from the Properties screen for the chosen input. The

following screen will appear.

Click the down arrow in the Response Type menu and choose Camera. Select the name of the cam-

era from which you would like to receive snapshots. Next, select the E-mail address where you

would like the snapshots to be sent. There are two options to determine the Duration over which

snapshots will be sent. If you choose While in Alarm you will receive snapshots continuously until

Figure 21: Alarm Response screen for PowerGate

Figure 22: Camera Alarm Response

Table of Contents