Connecting The Dvr - SubC Imaging DVRO User Manual

Table of Contents

Advertisement

GETTING STARTED

Connecting the DVR

You can view media related to this product at:
An uninterrupted power supply (UPS) is strongly recommended for all DVR installations. SubC can provide, install,
and support a warranty for your UPS when purchased with our DVR.
*Note: See following page for 1x 4K, 4x HD setup*
1.
Connect the supplied peripherals (keyboard, mouse, etc) to the USB inputs. The black USB 2.0 ports in the
upper part of the
orange
take advantage of their increased throughput.
2.
Plug your monitor's video cable into the appropriate port on the video card (red). From left to right: DVI-D,
HDMI, or VGA.
3.
Insert female end of power cord into power supply
4.
Set rear main power switch to the I (on) position and then power on by pressing the dot switch behind the right
door on the front panel. Allow Windows to boot. The DVR software will start automatically.
5.
The audio inputs
(Dark Yellow)
**Do not attempt to record from multiple inputs until referring to the manual.
Maximum of 4 channels of input with one of the following combinations:
4 Channel Composite SD in
2 Channel SDI HD/3D in
4 Channel SD Ethernet in
2 Channel HD Ethernet in
http://subcimaging.com/product/subc-dvr-and-overlay-hd-sd/
area will suffice. You may wish to save the blue USB 3.0 ports for devices that can
(blue)
can be used to connect a microphone in the pink port.
and plug male end into wall outlet or UPS.
Maximum of 4 channels of output:
2 Channel SDI out (using an SDI output ties up an SDI input)
1 Channel HDMI out (additional USB to HDMI out available)
1 Channel DVI out
Page 9

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DVRO and is the answer not in the manual?

Table of Contents