Menu - Measured Variables - Fronius TS 65A-3 Operating Instructions Manual

Location of the primary meter at the feed-in point. *Terminating resistor R 120 Ohm
The following must be observed in a multi-meter system:
-
-
-
-
Menu - Measured
Image
variables
Connect the primary meter and the battery to different channels (recom-
mended).
The remaining Modbus participants must be distributed equally.
Only assign each Modbus address once.
Terminating resistors must be positioned individually for each channel.
Scree
n
Description
00 1. Total active energy drawn*
Total efficiency
2.
01 1. Total active energy supplied**
2. Total efficiency
02 Total active energy drawn*
1.
2. Average conductor voltage in the system
03 1. Total active energy drawn*
2. Average phase voltage in the system
27