Vitrifrigo DW Series Instruction Manual page 35

Removing the drawers (Lateral guides)
To remove the drawers from the sliding guides, press on the two levers, right and left, in
the guides (Annex 5 - Fig.1).
Removing the drawers (Lower guides)
To remove the drawers from the sliding guides, press on the two orange mechanisms at
the bottom of the drawer and then lift it (Annex 5 - Fig.2).
Replacing the LED light
ATTENTION: Replacing the LED light must be done by a suitably qualified person who is
able to adopt all the appropriate safety measures.
Before replacing the light, make sure that the refrigerator is not connected to any
electrical supply. If connected, unplug the appliance from the electrical supply.
ATTENTION: When replacing it, do not damage the magnetic control reed.
9.3
To replace the LED light board, in both types of board (Fig. 9.3 & Fig. 9.4), proceed as
follows:
1. Remove, perpendicular to the base, the protective cover, being careful not to
damage the fixing pins.
2. Disconnect the light's power cables.
3. Replace the LED light profile.
4. Connect the power source.
5. Reposition the protective cover.
Removing the stainless steel front panel (DW models)
Remove the drawer from the guides to remove the stainless steel front panel (Annex
5 - Fig.1). Then follow the instructions in Annex 6 to remove the stainless steel front panel.
9.4
ENG 35