Quantum DX Series User Manual page 55

select
Quantum DX30
application recognize the device as a
respectively.
DX100
Quantum recommends that the device configuration be set
Note:
to
ATL P1000
supports the DX-Series inquiry strings. If your backup
application does support DX30 and DX100, you should
select that setting for improved performance.
4 Select the number of tape drives (emulated DLT7000) available to the
host and backup application in this partition. The Default partition
contains 6 tape drives at the time of installation, however, you can
change the number of drives (DX30 up to 30 tape drives; DX100 up to
55 tape drives).
If all tape drives are assigned to other partitions, you must
Note:
unassign one or more tape drives to make them available
for a new partition. Be aware that in a DX30, all tape drives
are assigned to the Default partition at the time of
installation.
5 Enter the number of empty bins available in addition to the number
of cartridges created in the partition. The default number of empty
bins is 0 and up to 28 empty bins can be selected.
6 Select the number of tape cartridges from the
list and click the right arrow button to move the cartridges into the
partition.
If all tape cartridges are assigned to other partitions, you
Note:
must unassign one or more tape cartridges to make them
available for a new partition. Be aware that all cartridges
that were created at the time of installation (see
Cartridges
partition.
7 Click to create the partition.
Apply
Map the Fibre Channel ports as described in
Channel Options on page 49.
Quantum DX-Series User's Guide
Chapter 3 DX-Series Remote Management
or , the host and backup
Quantum DX100
Quantum DX30
unless your specific backup application
on page 118) are assigned to the Default
Configuration
or
Quantum
Available Tape Cartridge
Creating
Configuring the Fibre
37