Quantum DX Series User Manual page 138

Appendix B Setup CD and Setup Menu
DX-Series Setup Menu
Displaying
2
Diagnostic Data
120
cartridge. For example, if you select 20 GB per cartridge, the
number of cartridges per RAID set is 80. If you select 1700 GB per
cartridge, the number of cartridges per RAID set is 1.
The capacity estimates mentioned in the examples above
Note:
assume a RAID 5 configuration on the storage array with
"global hot" spare. If a "global hot" spare is not used, the
total capacity is increased by 400GB. If two "global hot"
spares are used, the total capacity is decreased by 400GB.
6 The cartridges are created on the storage arrays. Press
continue.
The DX-Series Setup Menu displays.
7 Type 5 to restart the DX software services.
Restarting DX software services does NOT reboot the
Note:
DX-Series system and takes much less time to complete.
The DX-Series system is now initially configured and ready to be
accessed via the management web pages. Disconnect the cable from
the DX-Series controller serial port.
Displaying diagnostic data is included in the DX-Series controller
software. It collects status information from the controller and the array
so it can be analyzed by Quantum.
When trouble shooting any hardware failure within the
Tech Tip:
DX-Series hardware, have the diagnostic data prior to
calling Quantum customer support.
To display diagnostic data:
1 Connect the service PC to the DX-Series controller (see
the Controller on page 113).
2 At the system login prompt, type setup (all lower case characters)
and press
<Enter>
The system prompts you for a password.
Quantum DX-Series User's Guide
.
to
Enter
Connecting to