Wi-Fi Test; Equipment Needed; Set Up - ZOLL AED 3 Service Manual

Wi-Fi Test

Equipment Needed

Battery Test Fixture, Power Supply, Wi-Fi Access Point.
NOTE To test the server connectivity, the AED must be connected to an access

Set Up

Set the Power Supply to 12 volts.
•
Connect the Battery Test Fixture to the Power Supply.
•
Action
1. Press and hold the On/Off button
for more than 5 seconds to turn
on the AED in AED Management
(Non-Rescue) Mode.
2. Press the Device Configuration
icon
(
3.
Press the Supervisor icon
and enter the six-digit passcode
(default passcode is 123456) and
press OK.
4. Press the Device History Wi-Fi
icon
(
5. Press the Quick Setup button.
6. Press the Network Search icon
.
( )
7. Select your wireless network that
you want to connect to, and press
OK.
8. In the Password field, click on the
arrow and enter the network
password (if required), and then
click OK.
14
point. For more information, refer to "Setting up your Wireless
Configuration" in the ZOLL AED 3 Administrator's Guide.
.
)
( )
.
)
ZOLL AED 3 Service Manual
Expected Result(s)
Verify that the AED displays the
Select Operating Mode window.
Verify that the AED displays the
Configuration window.
Verify that the AED displays the
Advanced Configuration window.
Verify that the AED displays the
Wi-Fi Setup Level window.
Verify that the AED displays the
Clinical Archive Quick Setup window.
Verify that the AED displays the
SEARCHING FOR WIRELESS
NETWORK message and a flashing
IN PROGRESS message.
Verify that the AED displays the
Clinical Archive Quick Setup window.
Verify that the AED displays the
password in the password field.
Pass/Fail
o o
o o
o o
o o
o o
o o
o o
o o
9650-000761-01 Rev. A